Filter
Top Products
SERVICE
To change direction of handle rotation, proceed
as follows:
Turn valve to OFF position.
Remove HANDLE and ADAPTER if present.
Remove SPRING CLIP (1).
Lift STOP WASHER (2), turn 90p and replace.
Replace SPRING CLIP (1).
Replace HANDLE ASSEMBLY.
Replace SPRAY (3) and operate handles several times from
OFF to ON position. Do not force, handles turn only 90˚.
SPRAY (3) may accumulate dirt causing distorted and reduced
water flow. Unscrew and remove SPRAY (3) and rinse clean.
.3&7
90p
1
2
3
Operate Lift Rod (3) and fill Bidet with water. Check that DRAIN
STOPPER (4) makes a good seal and retains water in Bidet.
Adjust stopper height by repositioning Lift Rod (3) with
EXTENSION ROD (6) and tightening Thumbscrew (5).
Release DRAIN STOPPER (4) and check all drain connections
for leaks. Tighten if necessary.
TEST INSTALLED FITTING
With HANDLES (1) in OFF position, turn on WATER SUPPLIES (2)
and check all connections for leaks.
Operate both handles to flush water lines thoroughly.
Turn diverter to rim wash and bidet spray.
1
3
3
6
5
4
2
2
American Standard’s EverClean finish will wipe clean with a soft, dry cloth. A soft cloth with clean
water may also be used, if desired. No additional cleaning products are required.
DO NOT USE: Soaps, acid, polish, abrasives, harsh cleaners, or a cloth with a coarse surface.
EverClean™ Finish Care Instructions