Filter
Top Products
7
GB
CONTROL PANEL AND OPERATION
1
2
3
4
ON and humidity level control [2]
Turn the humidity control knob to the OFF position before connecting to the mains.
Set the humidity controller to the required humidity level or fully clockwise to the
maximum position for continuous working.
By rotating the knob clockwise the unit will switch off at a lower relative humidity,
i.e. it will extract more.
OFF
To turn off the unit, turn the humidity controller fully anticlockwise to OFF. Indicator
light [3] will go out.
Fan speed control [1]
This dehumidifier features a twin speed fan. To select required fan speed press fan
speed switch as shown.
In normal conditions, set the speed to high
. For quieter operation, set the speed
to low .
Water container full indicator [4]
When the water container is full the unit will switch off and the indicator will
illuminate (see "Emptying the water tank" how to proceed).
Remarks:
1. The unit does not run when the set humidity level is higher than the relative
humidity in the room.
2. To protect the compressor from possible damage, please wait three minutes after
turning off the unit before switching back on again.
3. The working temperature is 5 - 35 °C.
4. When the unit runs the expelled air is warmer than the room air.
5. When the unit does not start (indicator light [3] is out), check if cable and
electricity function as they should, wait for 10 minutes. If the unit then does not
start, call for assistance.