Filter
Top Products
3
6
Placement of the AM-80 Air Purifier
Attention: Before deciding on a location for your AM-80 Air
Purifier, carefully read all the operating instructions as well as
all the following information.
1. Do not place this unit in close proximity to electronic devices that are
sensitive to electrical fields.
2. Do not place this unit on metal shelving or on any electrical device.
The AM-80 Air Purifier may be placed on the floor, nightstand, table or desk
with its air outlet facing the user in order to allow proper air flow.
3. IN ORDER TO PREVENT DIRT BUILD-UP, IT IS RECOMMENDED TO KEEP
THE UNIT AT LEAST 1.5 FT. (45 CM) FROM ANY NON-WASHABLE SURFACE.
The principle upon which the ionizer works is ionization. The process of ionizing
accelerates the fallout of pollutants from the air. These pollutants may adhere to
surrounding surfaces, causing a dark smudge. Therefore placement of the unit away
from
ALL NON-WASHABLE SURFACES
is a must!
Instructions for Use of Your Air Purifier
The AM-80 Air Purifier may be operated all day and all night. The air-flow can be
regulated either by the power switch or by moving the AM-80 Air Purifier towards
or away from the user.
CONTROL AND INDICATOR LIGHTS (fig. I):
1. The fan control is a three position-switch, marked “POWER”. The switch controls
the power to the unit and allows the user to select either high or low fan speeds.
When the unit is on, the POWER INDICATOR will be lit.
2. The ION CONTROL SWITCH is marked “IONIZER”. When this switch is
turned on, the IONIZER INDICATOR is lit and the unit releases negative ions
into the room.
Note: The ionizer does not operate unless the AM-80 Air Purifier is turned on
(either position “HI” or “LOW”).
Ionizer Switch
Ionizer Indicator
Ionizer Indicator
Power Switch
Routine Service and Cleaning
Regular maintenance of the unit will maintain its effectiveness.
BEFORE CLEANING THIS UNIT UNPLUG IT FROM THE ELECTRICAL OUTLET!
1. Enclosure Cleaning
Clean the outside of the unit at least once a week with a damp paper towel moistened
with a common household detergent.
Use a soft brush to clean (lengthwise) the carbon filament on the front of the outlet
grill. Make sure not to damage the carbon filament during the cleaning process.
2. Cleaning the Area Around the Unit
Wipe the area around the unit once a week with a wet paper towel to remove any
accumulation of dust.
3. Cleaning the Washable Filter
It is recommended to clean the pre-filter every 8 weeks.
To Clean the Pre-filter, Follow these Steps:
1. Face the air intake grill (back of unit).
2. Press and release the filter cover (fig. 2).
3. Detach the pre-filter foam sheet from the retaining “Velcro” strips (fig. 3).
4. Shake dust out of the pre-filter. You can wash the pre-filter sheet in mild detergent,
rinse and air-dry thoroughly (do not place in automatic dryer).
5. Re-attach the pre-filter sheet to the retaining “Velcro” strips (fig. 4).
6. Replace the filter cover, bottom edge first, and snap into place (fig. 5).
fig. I
fig. I
fig. I
fig. I
fig. I
fig. I
fig. I
fig. 2 fig. 3 fig. 4
fig. 5 fig. 6 fig. 7
fig. 5 fig. 6 fig. 7