Filter
Top Products
8
Air flow direction
Adjust the fins (vertical vanes) in the indoor unit by hand
to change the left-right air flow direction so that it is
comfortable to you.
Press the
VANE CONTROL button to change the horizontal direction of the air
flow, the vanes take these positions in sequence: .
Usually the auto position works fine.
Positions (1) and (2) are recommended for cool and
dehumidify mode.
After one hour of operation in position (4) or (5), the vane
position will revert to level in order to prevent condensed water
dropping down the vanes.
Manually handling of the vanes may cause damage, use the
remote control.
Do not expose anybody to the cool air for a long period of time. This may
discomfort the body which may be harmful to the health.
Auto restart
As a protective measure of the compressor, the air conditioner will automatic
restart 3 minutes after electricity is restored following a power cut. If in doubt,
check the settings.
Note: After shut down you have to wait 3 minutes before you can restart.
Range of internal thermostat
The internal thermostat can be set at a desired temperature between 64 °F
(18 °C) and 86 °F (30 °C).
Note: whether the desired value is achieved depends on conditions in the
room.
Capacity
The required cooling capacity depends greatly on the location and/or use
of the room where the air conditioner is installed. Strong sunlight and the
presence of people, lights or equipment create an additional heat load.
Normal living spaces require about 35 BTU per square feet of floor surface
(~100 W/m
2
). In strong sunlight or if other sources of heat are present, this
may be as much as 125 BTU/ft
2
.h (~350 W/m
2
).
Tip: on warm days, let the air conditioner cool the room as much as possible
during the night. Cold walls and furniture will help to keep the room pleasant
during use. Avoid strong sunlight.
IMPORTANT