Filter
Top Products
6
ON/OFF and timer function
Turn the control [1] to switch the unit on or off. When the unit is on, LED-1 is on.
Timer function
Use control [1] to set a working time between 1 and 8 hours. The unit switches off
when the set time has run down.
Mode selection and speed setting
Select with control [2] the required operating mode cooling or fan mode. The
corresponding LED (2 or 3) will lit.
Select the larger symbol position for high or low fan speed, or low or strong cooling.
Thermostat setting
Turn control [3] to maintain the temperature level in combination with cooling.
Notices:
• The compressor has been set so that it starts functioning three minutes after the
(re)start of the air conditioner.
• The cooling will switch off when the room temperature is lower than the set
one. Ventilation will however continue to work on the set level. When the room
temperature rises above the selected value, the cooling will work again.
Air flow
Turn the roller to control the air flow direction of the vertical
louvres.
Move the air vent directly to adjust the air flow direction of the
horizontal louvres.
OPERATION
GB
3 2 1
1 2 3 4