Amcor 12KE-410 Air Conditioner User Manual


 
8
Important: how to wire a 13 amp plug
The wires in the mains lead on this appliance are
coloured in accordance with the following code:
GREEN AND YELLOW – EARTH BLUE – NEUTRAL BROWN – LIVE
As the colours may not correspond with the markings
identifying the terminals in your plug proceed as
follows:
The
GREEN AND YELLOW wire must be connected to the
terminal in the plug which is marked with the letter
E or with the earth symbol
or coloured green and
yellow.
The BLUE wire must be connected to the terminal marked N or coloured black.
The BROWN wire must be connected to the terminal marked L or coloured red.
ELECTRIC CONNECTION
GREEN/YELLOW
Earth
BLUE
Neutral
BROWN
Live
FUSE
13 Amp
Cord clamp
GB
STORAGE
First of all switch off the unit and pull the plug.
Clean the housing with a soft, damp cloth. Never use aggressive chemicals, petrol,
detergents or other cleansing solutions.
Filter
The single layer screen filter cleans the circulated air. The filter needs to be cleaned
regularly with a vacuum cleaner to avoid blocking the air flow.
Push the two clips on the filter housing downward and pull the filter housing
forward and out of the unit.
Remove the rear retainer from the housing by gently prising it from the retaining
clips.
Insert the screen filter aligning the two cut outs with the clips on the top of the
filter housing.
Reverse the procedure to re-fit the housing in the air conditioner.
Notice! Never use the air conditioner without filter.
See the instructions "Emptying the water container" on page 7.
Drain the condensed water completely.
Clean (or replace) the filter.
Put the unit on a sunny day in fan mode for a couple of
hours to ensure that the inside becomes completely dry.
Store the power cable as shown, protect the unit against
dust and store in a dry place not accessible for children.
Cable storage
CLEANING