Filter
Top Products
ENGLISH
USER MANUAL
26
33014818(2)2006-12 A SR 1800S
Problem Possible cause Remedy
CLIMATE CONTROL SYSTEM
There is no fresh air
The compressor is malfunctioning
Replace the belt
Replace the compressor
There are gas leaks from the system
Check the line
Supply with gas
The expansion valve is faulty Replace the valve
The switch is not turned on Turn on the switch
The fuse is burned Replace the fuse
The gas pressure switch is faulty Replace the pressure switch
The relay is burned Replace the relay
ELECTRICAL SYSTEM
The turn signals are faulty
The fuse is burned Replace the fuse
The bulb is burned Replace the bulb
There is an open in the combination switch Replace the combination switch
The warning switch is damaged Replace the switch
The intermittence is burned Replace the intermittence
The brake lights are faulty
The fuse is burned Replace the fuse
The bulb is burned Replace the bulb
The microswitch is faulty Replace the microswitch
The running lights are faulty
The fuse is burned Replace the fuse
The bulb is burned Replace the bulb
There is an open in the combination switch Replace the combination switch
The low beams are faulty
The fuse is burned Replace the fuse
The bulb is burned Replace the bulb
There is an open in the combination switch Replace the combination switch
The relay is burned Replace the relay
The high beams are faulty
The fuse is burned Replace the fuse
The bulb is burned Replace the bulb
There is an open in the combination switch Replace the combination switch
The relay is burned Replace the relay
The horn is mute
The fuse is burned Replace the fuse
The horn is faulty Replace the horn
There is an open in the combination switch Replace the combination switch
The relay is burned Replace the relay
The battery does not keep the charge
The fl uid is insuffi cient Supply with fl uid
There is a short circuit in the battery
elements
Replace the battery
The battery terminals are loose Check and tighten the terminals
The motors are overloaded Check the motor electrical input
The battery runs out of charge fast
The charging cycle is too short Extend the charging cycle
The battery elements are dead Replace the battery
SCRAPPING
Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to
the law in force:
Brooms
Engine oil
Engine oil fi lter
Hydraulic system oil
Hydraulic system oil fi lters
Plastic components
Electrical and electronic components
NOTE
Refer to the nearest Nilfi sk-Advance Center especially when scrapping electrical and electronic components.
–
–
–
–
–
–
–