Filter
Top Products
USER MANUAL
33014817(2)2006-06 A 11
Stop (SR 1800C D)
Turn the ignition key counterclockwise to “0” position and then
remove it. Pull the parking brake lever.
Start (SR 1800C B)
– Before starting the machine, make sure the parking
brake (5, Fig. L) is engaged.
– Connect the battery cable socket with the machine cable
plug.
– Be sure of the perfect connection.
– Insert the ignition key in the ignition switch.
– Turn clockwise to the first position.
– The battery charge indicator light should be on.
– Turn the ignition key clockwise until the end of stroke.
When the motor is on, release the ignition key which will
automatically return to the first position.
Stop (SR 1800C B)
Turn the ignition key counterclockwise to “0” position and then
remove it. Pull the parking brake lever.
MACHINE USE
Waste collection
– Turn the accelerator lever to the maximum speed
position.
– Lower the lever to operate the fan.
– Skirt opening: pull the distributor lever.
– Make sure that the skirt closing panel is completely
open.
– To start and lower the main broom, push the distributor
lever to the left.
– To start and lower the side broom, pull the distributor
central lever.
When necessary, dump the hopper as follows:
– Lift the main broom.
– Lift the side broom.
– Stop the fan.
– Close the skirt.
– Drive the machine to the appointed dumping area.
– Lift the hopper to the correct dumping height.
– Open the skirt.
– Lower the hopper.
– Close the skirt.
– Lower the hopper.
– Activate the filter shaker for approx. 20 seconds.
– To stop and lift the main broom, push the distributor lever
to the right.
– To stop and lift the side broom, push the distributor
central lever.
– Lift the lever to stop the fan.
– Push the lever to close the skirt.
– Pull the lever to lift the hopper to the required dumping
height.
– Open the skirt by pulling the lever to dump the hopper.
– Close the skirt after dumping.
– Push the distributor lever to lower the hopper.
– After dumping and with the hopper in the lowered
position, activate the filter shaker for approx. 20 seconds
by pressing the relevant push-button.
MACHINE STOP
At the end of the working shift, stop the sweeper in the
appointed area with:
– Brooms in the lifted position;
– Hopper in the lowered position;
– Parking brake lever engaged;
– Lights off (if on);
– Engine off;
– Ignition key removed.
NOTE
Before trying to start the machine again, turn
the ignition key back to “0” position.
As soon as the machine has been started,
check the battery charge, oil pressure and
pre-heating warning lights are off.
WARNING!
Move the machine extremely slowly when the
hopper is in the lifted position.
Maximum speed 1 km/h.
Do not dump the hopper with the machine on a
slope.
WARNING!
When dumping the hopper, make sure that
nobody is near the machine.
WARNING!
Do not activate the filter shaker with the hopper
in the lifted position.
WARNING!
Never leave the hopper in the lifted position
without using the safety props (1, Fig. M).