Filter
Top Products
ATTIX 8 GALLON
ATTIX 8 GALLON AS/E
5
english
– flammable, explosive dust
(e.g. magnesium or alu-
minium dust, etc.)
Appliance socket
Use the socket on the vacuum
cleaner for the purpose defined
in the operating instructions
only.
Before plugging an appliance
into the appliance socket:
1. Switch off the vacuum
cleaner
2. Switch off the appliance to
be connected.
CAUTION!
Follow the operating instruc-
tions and safety instructions for
appliances connected to the
appliance socket.
Before starting the vacuum
cleaner
Before starting the vacuum
cleaner, check that it is in
proper condition. Plugs and
couplings in power cords must
at least have splash protection.
Regularly check whether the
power cord is damaged or
shows signs of aging. Use the
vacuum cleaner only if the
power cord is intact (risk of
electrocution in case of dam-
age).
Never use the vacuum cleaner
if the filter element is damaged.
During use
Do not damage the power cord
(e.g. by moving over it or pulling
or squeezing it).
Disconnect the power cord by
pulling the plug only (do not pull
or tug the power cord).
CAUTION!
Before sucking in liquids,
remove the filter bag and check
the performance of the floater
(see section 7.2.3).
When sucking in liquids, always
use a filter element or filter
screen (for order number see
section 9.5 "Accessories").
If foam appears, stop work
immediately and empty the
tank.
Maintenance and repair
CAUTION!
Always pull out the mains
plug before cleaning and
servicing the vacuum clea-
ner.
Only carry out maintenance
work described in the operating
instructions.
CAUTION!
Use original Alto accessories
and parts only. The use of other
parts can adversely affect
safety.
CAUTION!
Do not make technical modifi-
cations to the vacuum cleaner.
They could endanger your
safety.
For further maintenance or
repair work and the replace-
ment of a faulty power cord
please contact the Alto service
department or an authorized
Alto workshop.
Electrical connections
Check the rated voltage of the
vacuum cleaner before con-
necting it to the mains supply
system. Ensure that the voltage
shown on the rating plate
corresponds to the voltage of
the local mains power supply.
If you are using an extension
cord, use only those specified
by the manufacturer or higher
quality ones (see section 9.4
"Technical data").
It is recommended that the
vacuum cleaner is connected
via a residual current circuit
breaker. This device stops the
supply of electricity if the
leakage current to earth ex-
ceeds 30 mA for 30 ms or it has
an earth tester circuit.
When using an extension cord,
check the minimum cross-
sections of the cable:
Cable length Cross section
mmm
2
up to 20 1.5
20 to 50 2.5
Arrange the electrical parts
(sockets, plugs and couplings)
and lay down the extension
cord so that protection class is
maintained.
CAUTION!
Never spray water on to the
upper section of the vacuum
cleaner: danger for persons,
risk of short-circuiting.
Observe the latest edition of the
IEC regulations.