Filter
Top Products
40
10.2 Service/maintenance guide - Centix 40 / Centix 50 Premium
Dust
container
Should be emptied
before the container
is 3/4 full, depending
on use but normally
2-4 times a year.
Danger of
blockage in the
pipe system.
Remove the hose from the machine. Then loosen the
handles on the container (pull out from the machine) to
free the container from the machine. Lift out the fi lter
and dust bag - see additional information below. Empty
the dust into a plastic bag and put in dustbin. Any
remaining dust or fl uff can be removed manually.
Dust bag
Should be replaced
before it becomes
completely full,
depending on use but
normally 2-4 times
a year.
Poor suction
and danger
of creating a
blockage
in the pipe
system.
Remove the hose from the machine. Then loosen the
handles on the container (pull out from the machine)
to free the container from the machine. Lift off the
container. Lift out the fi lter. Then remove the dust bag
by pulling the bag’s cardboard stiffener off the nozzle.
Replace in reverse order.
Should be shaken
when the container is
emptied.
NB: Only use dry
cleaning methods
To maintain good
suction power.
Filter
NB! Never vacuum without a fi lter installed.
Start by pulling the hose out of the dust container.
Loosen the handles on the container by pulling the
handles in an outward direction from the machine.
Remove the container from the machine.
Do not remove the fi lter from the container. Instead, give
the fi lter a light shaking inside the container to loosen
dust from the fi lter and allow it to fall into the container.
Lift out the bag fi lter. If a dust bag is being used -
remove it. Then empty the dust from the container in a
suitable place.
Should be replaced
before it becomes
completely full,
depending on use but
normally 2-4 times a
year.
Poor suction and
danger of
creating a
blockage in
the pipe system.
Dust bag
Grasp the edge of the lid and open it by pulling upwards.
Remove the old dust bag by turning the cardboard
stiffener to the right or left so that the elevation on
the nozzle penetrates the opening in the cardboard.
Now slide the bag off the inlet. Push the opening in the
cardboard over the elevation on the inlet and pull on
the new bag. Twist the cardboard to lock the bag in
place. NB! The opening in the card must be adjusted
and pushed past the elevation on the inlet before the
cardboard can be locked into place with a twisting action.
NB! Never vacuum without a dust bag installed.
Filter in
bottom
Should be checked
when changing
the bag.
Poor suction can
result. Dust can
fi nd its way into
the motor.
10.1 Service/maintenance guide - Centix 20
Remove the dust bag as described above. Remove
the fi lter from the bottom. The fi lter can be cleaned by
shaking it or washing it in water. NB! The fi lter must be
completely dry before being reinstalled. Replace the
cleaned fi lter in the machine. Press the outer edge of the
fi lter down against the sides of the container so that the
fi lter bulges up slightly. Refi t the dust bag and replace the
lid. Check that the lid is sitting fi rmly in place.
NB! Never vacuum without a fi lter installed.
NB! Never vacuum without a fi lter and dust bag installed.
Product How often? Why? How?
Product How often? Why? How?