Filter
Top Products
10
en
23
20 22
Putting into operation
The best location for your appliance is:
• On the floor, or on a level, dry surface in the room.
• Pay proper attention to easy accessibility and sufficient
space for servicing and cleaning the unit.
• For increased evaporation performance in large rooms,
place the appliance near a radiator (warning: a tempe-
rature of 122 °F / 50 °C must not be exceeded).
• Read the section “Filling the tank” on how to fill the
water tank (20 – 24).
• Place the water tank on the lower part (24).
• Connect the mains cable to the mains and switch the
appliance on using the On/Off switch.
• The unit will reach full capacity about 10 – 15 minutes
after you switch it on.
• Ensure that the mains cable is not trapped (9). Do not
switch on the unit if the mains cable is defective (2).
Filling the tank
Always unplug the unit before removing the wa-
ter tank. Do not operate the appliance when the
water tank is empty!
Only fill the water tank with fresh, cold tap water. Use other
solution at your own risk. We do no accept any liability for
possible reductions in performance or damage.
Do not put the water tank under pressure, e.g. by filling with
carbonated mineral water. Do not add any essential oils or
fragrances to the water; the plastic material might then
become discoloured and damaged. Close bayonet cap (23)
fully to prevent water from leaking out of the tank.
• Remove the water tank (20).
• Ensure that there are no foreign objects in the water
tank.
• Remove the water tank cap from the tank (21). Fill the
tank with fresh, cold tap water (22). Fully close the
bayonet seal to prevent the water tank from leaking
(23). Place the water tank on the water base (24).
21
24
25
• Connect the mains cable to the outlet and switch the
appliance on.
The 2055D (digital) unit is fitted with an automatic cut-
off switch. As soon as the water tank is empty, the unit
switches off automatically. The empty indicator illuminates
(also see section “Operation 2055D”). This function is not
available on the 2055 unit.
Use of fragrances
The base contains a special fragrance container (25). Wad-
ding soaked with fragrance can be placed in this container.
Place fragrances only in the container provided! Water ad-
ditives (e.g. essential oils, fragrances, water conditioners)
must NOT be used in the tank or anywhere else in the appli-
ance! Even a small amount can damage the plastic or cause
cracks. The material is not suitable for the use of additives.
One drop is enough to damage the water tank and therefore
render the unit unusable. Appliances that are damaged by
additives are excluded from the warranty. The fragrance
container is also used as a tool for opening the rotary locks
of the humidifying discs. To learn more about removing the
discs, refer to section „Cleaning the humidifying discs“.