Filter
Top Products
Ð 6 Ð
SYSTEM OVERVIEW (Continued)
Phone Access &
Voice Response
Capability
Your system may include a voice module that will permit you to access the system via a Touch-
tone phone, either on-premises or by call-in when away. The phone access feature will enable
you to do the following:
¥ Receive synthesized voice messages over the telephone regarding the status of the
security system.
¥ Arm and disarm the system and perform most function commands via the telephone, with
voice confirmation provided after each command entry.
Complete information regarding the use of this feature is provided in a separate manual entitled
PHONE ACCESS USER'S GUIDE, which accompanies the voice module.
Paging Feature If the paging feature has been programmed for your system, a pager will respond to certain
conditions as they occur in your system. The pager will display code numbers indicating the
type of condition that has occurred. Refer to the PAGING FEATURE section later in this manual
for detailed information.
Single-Button Paging
The touchpads have a special key (identified as the ÒDÓ key) which may be used to signal a
Pager. The message displayed on the Pager when this key is pressed is 999–9999. This code
could mean Òcall homeÓ, Òcall your officeÓ, or whatever you decide this code will mean. See
SINGLE-BUTTON PAGING FEATURE section.
Single-Button
Arming Feature
Check with your installer
if single-button arming is
present in your system
.
If programmed for your system, keys A and B on the touchpads may have been programmed for
single-button arming without the use of a security code, as follows:
Key A, when pressed for 2 seconds, will arm all protection (AWAY mode).
Key B, when pressed for 2 seconds, will arm the perimeter (STAY mode).