Filter
Top Products
Aarrow Ecoburn Wood & Multifuel Stoves 21
SERVICE & MAINTENANCE
ANNUAL MAINTENANCE
It is important that your fir e is regularly serviced in
accordance with these instructions. This should be
carried out at least annually by a qualified person
and should consist of the following.
Remove the fire lining(s), and throat plate, inspect
all gasketing on doors, glass etc. and re-order any
items that may need replacing, from your Aarrow
dealer. W ith a wire brush clean inside the appliance
paying particular attention to the small inlet holes
of the air wash on the inside of the stove, above the
fire door. Ensure the inside face of the fire door is
free of debris around the area of the primary air
inlet.
Sweep the chimney and confirm that it is sound.
Examine all joints in the flue pipe etc. and re-seal if
necessary.
SUMMER STORAGE/NON USAGE
Please ensure that your stove is left clean and mov-
ing components are well lubricated for the summer
months (during periods of prolonged non use). If
possible store the throat plate outside of the stove,
check all movable components, at regular intervals,
to ensure they are moving freely.
Allow air movement through the stove, by opening
the airwash and prinmary air inlet(s) controls to
about half way open or leave the door ajar . This will
allow a free flow of air through the appliance thus
preventing moisture and condensation forming
inside the stove and chimney. This preventative
maintenance will ensure your stove stays in the best
condition for the coming winter months.
DOOR ADJUSTMENT
Once the appliance has been under fire for a period
of time the fire door may appear to have moved out
of alignment with relation to the door aperture.
This is quite normal and due to the settling of the
casing.
The fire door can be re-aligned by the user as
follows:
•When the appliance is cold, open the fire door so
that it is at a right angle to the front face of the fire.
•Lift the fire door up off the hinges. .
•Gently tap the two hinge pins in a direction to
compensate for the misalignment.(Fig.13)
•Refit the door and check to ensure it now sits
square to the body; if not repeat above steps.
Raising the door as follows:
•When the appliance is cold, open the fire door so
that it is at a right angle to the front.
•Lift the fire door up off the hinges.
•Drop one washer on the top and bottom hinge pin
.
•Refit the door and check.
Please Note: There is no adjustment to the door
lock/catch assembly.
Fig. 13. Adjusting the door hinge