Applicator Interface
The Applicator Interface is an ideal method of integrating XiII printers into
custom applications. This interface allows printer control from a personal
computer or Programmable Logic Controller (PLC) via one cable attached
to a connector located at the rear of the printer. This provides the capability
of placing the XiII printers on a production line in a loose loop, print and
apply configuration, or other applications where the printer must be con
-
trolled by a machine.
Media Supply Spindle
The optional Media Supply Spindle replaces the standard hanger. This is
useful for applications that require the printer to be mounted in a non-
horizontal position where the standard media hanger prohibits consistent
media flow.
Optional Media Supply Fins
Optional Media Supply Fins are available to convert the standard 3-inch (76
mm) core diameter to a 1.77 inch (45 mm) core for smaller core media rolls.
Simply remove the current fins and install the reduced-diameter fins.
Fonts
There is a wide range of optional character fonts that can be purchased for
your XiII printer in addition to those fonts which are standard in the unit.
Fonts may be purchased on EPROMs or on PCMCIA cards, depending on
your needs.
Refer to “Optional Printer Fonts” on page 85 for information about optional
fonts. From time to time, additions may be made to the list of available
fonts. Contact your sales representative for further information.
Zebra XiII-Series User’s Guide 73
85
H:...Xi2UsersGuideR2.vp
Fri Aug 07 10:36:57 1998
Color profile: Disabled
Composite Default screen
