E-35
English
General information
• When recording important selections, be sure to make a
preliminary test to ensure that the desired source material
is being properly recorded with good sound quality.
• The automatic recording level control circuit automatically
controls the level of the input signal used for recording.
• Adjusting the VOLUME control has no effect on the
recorded sound.
If, however, the built-in graphic equalizer and/or sound
field processor is used, its effect is recorded along with
the source.
* Music with an equalizer effect is suitable for listening to
inside a car etc.
• For the tape deck, the deck which can be used for
recording is deck 2 only. When recording, be sure to load
a tape into the deck 2 cassette compartment.
• Recording cannot be done if the tape deck is selected as
the playback source.
CD synchronized recording
1 Press the CD input selector button and load the disc to be
recorded.
2 Load a tape into the deck 2 cassette compartment.
* Wind past the beginning part of the tape on which
recording cannot be performed.
3 When recording with the Dolby NR system, press the
DOLBY NR button so that “ B” lights up on the display.
If not, turn it off.
* For details, refer to the “Dolby B Type Noise
Reduction” on page 31.
4 If desired, switch the reverse mode by pressing the
reverse MODE selector button.
When the tape is set so that side A faces you, recording will
be done as follows automatically according to the selected
reverse mode.
5 Press the REC/PAUSE button.
* “REC” lights up on the display.
6 Start CD playback by pressing the corresponding DISC
selector button, or by pressing the play/pause /
button if the disc is already selected.
* Before CD playback begins, recording automatically
begins on the side of the tape now selected.
RECORDING COMPACT DISCS
3 4 5 2
