Model MRC44 Page: 11
© 2002 Xantech Corporation
26. Source 2 Selector. Selects source input 2, reverses source icon on LCD Display when source is selected
and sends IR commands programmed to this button (if any) to the source 2 and common emitter outputs.
Also used in Dynamic Monitor Lockout and Dynamic Zone Link Modes.
27. Source 3 Selector. Selects source input 3, reverses source icon on LCD Display when source is selected
and sends IR commands programmed to this button (if any) to the source 3 and common emitter outputs.
Also used in Dynamic Monitor Lockout and Dynamic Zone Link Modes.
28. Source 4 Selector. Selects source input 4, reverses source icon on LCD Display when source is selected
and sends IR commands programmed to this button (if any) to the source 4 and common emitter outputs.
Also used in Dynamic Monitor Lockout and Dynamic Zone Link Modes.
29. Vol
+. Increases zone volume and moves the Volume Bar on the LCD Display to indicate volume level
(non-programmable).
30. Vol
-. Decreases zone volume and moves the Volume Bar on the LCD Display to indicate volume level
(non-programmable).
31. Mute. Mutes zone speaker output. Sends IR commands programmed to this button (if any) to the selected
source and common emitter outputs.
32. CH
+. Sends IR commands programmed to this button to the selected source and common emitter outputs.
33. CH
-. Sends IR commands programmed to this button to the selected source and common emitter outputs.
34. Status. Displays zone and system status (zone/source activity, linked zones, audio setup, etc – non-
programmable).
35. Select/Play, Stop, Pause, Rew, FF. Each send IR commands programmed to these buttons to the
selected source and common emitter outputs.
4337 36
41
42
39
38
40
43
Figure 5 – The Model MRC44 Keypad – Rear Panel Features and Functions
