1. For vented applications, see Figures.3 4, and 5. Typical
vented installations are shown for the 7” Round Vertical,
3% x 10 Vertical, and the 3% x 10 Horizontal Discharge
respectively. Choose the best method-for your installation.
2. Mark locations on cabinet or wall for ventilating duct and
electrical wiring from dimensions given in Frgure 1
3 Cut holes at marked locations to accomodate ventilating
duct and electrrcal wiring. Allow %” (1.91 cm) extra on
ventilating opening toward the front of cabinet directly
above the hood. Be sure to minimize openings through
outside walls or the ceiling These will have to be sealed
later.
4. Run wire through wall or cabinets according to the
Natronal Electrical Code and applicable local codes. DO
NOT turn power on until installation is complete.
5. Remove screws holding junclion box cover See Figure 7.
6. Ltft the hood into positron and mark the hole locations on
the cabinet for each of the four keyhole mounting slots.
IF RAIN CAP HAS
A DAMPER, REMOVE
DAMPER BLADE
FROM HOOD.
KEYHOLE SLOT
IN CANOPY
FIG. 4
FIG. 2
SCREW--I
(IN INSTALLATION
PARTS BAG)
LOCATE AS FAR
FROM HOOD AS
POSSIBLE
FIG. 3
VERTICAL VENTING
7” ROUND
VERTICAL VENTING
34
’ “x IO” RECTANGULAR
IF RAIN CAP HAS
A DAMPER, REMOVE
DAMPER BLADE
FROM HOOD.
I .
I,
(16% cm)
-LL==Jg
I
HORIZONTAL VEN
FIG. 5
ITING
Page 2
