. SET LOAD SJZE
l
SET WATER TEMPERATURE
. PUSH IN KNOB, TURN TO
CYCLE AND TiME
. PULL OUT TO START
SOAK CYCLE
Thus cycle IS r80t for btipcxhlng 11 smks ogl
totes specs out the tiater and stops 1~~0
rlwe) Use It for staned yeliobed grey or
heavllv so&a iaur,d-y tii+h o detergent
or pre sook product Chlorine bleach
If
wonted should be added to the cvcle vou
use after the SOAK Cycle IS over
If You Need
Service or Help,
We suggest You
Follow These Three
Steps:
1. Before calling for service ..,
Problems are sometlmes caused
by llttle things you con correct without
tools Check this IIst before you call
for service
IF YOUR WASHER DOES NOT FILL:
l
Is the power supply cord plugged In3
l
Are both water faucets open?
l
Are the water supply hoses kinked’
l
Is the Cycle Control Knob set and
pulled out’?
IF YOUR WASHER DOES NOT SPIN:
l
Is the IId closed’
l
Is the power supply cord plugged in3
l
Is a fuse blown or clrcult-breaker
tripped?
IF WASHER FILLS AND DRAINS WITHOUT
RUNNING:
l
Make sure ihat the Cycle Conirol
Knob IS pointing to a number in the
cycle.
IF YOUR WASHER STOPS DURING THE
PERMANENT PRESS CYCLE.
l
Remember, the washer will stop for
about 1’ z minutes after ihe partial drain
during the cool-down period In this
cycle
MAKE SURE THE DRAIN HOSE IS HIGHER
THAN THE WATER LEVEL IN THE WASHER.
IF IT ISN’T...
l
The washer may seem to be draining
during wash and rinse cycles.
l
Water can siphon out. (See Installation
Instructions )
l
Is a fuse blown or clrcult-breaker
trapped?
10
