9
9. Attach a Roller (39) between the indicated set of
holes in the Squat Slider (38) with an M8 x 85mm
Bolt (94) and an M8 Nylon Locknut (34). Do not
overtighten the Locknut; the Roller must be able
to roll easily.
Assemble the other three Rollers (39) to the
Squat Slider (38) in the same manner.
10. Orient the Squat Slider (38) as shown, and slide it
down onto the Squat Upright (4).
11. Insert the ends of two Weight Guides (42) without
holes into the indicated bracket on the Long Base
(101). Slide two Weight Bumpers (49) onto the
Weight Guides. Next, slide ten Weights (44) onto the
Weight Guides. Make sure that the Weights are
turned so the grooved sides of the Weights are
facing downward.
Press a Weight Tube Bumper (48) into the lower
end of a Weight Tube (43). Insert the Weight Tube
into the centers of the Weights (44). Make sure
that the Weight Tube is turned as shown.
Lubricate the two outer holes in a Top Weight (45).
Slide the Top Weight onto the Weight Guides (42).
Make sure that the Top Weight is turned so the
grooved side is facing downward.
Apply a number “10” decal to the Top Weight (45) in
the location shown. Apply decals with the numbers
20 through 110 to the ten Weights (44).
Assemble the other weight stack in the same
way.
9
10
49
101
Groove
Lubricate
43
48
42
45
44
“10” Decal
“110” Decal
11
42
38
4
39
39
39
94
34
38
“20” Decal
