7
6. Press the Large Dome Cap (7) into the Top
Upright (4).
Attach the Top Upright (4) to the Upright (3) with
f
our M10 x 25mm Button Head Screws (78), and
four M10 Lock Washers (21).
Attach the Name Plate (70) to the Top Upright (4)
with two M4 x 16mm Screws (62).
6
4
3
70
62
62
78
78
7
21
21
7. Attach two 8mm Metal Spacers (42), a 60mm
Metal Spacer (39), and two Bearing Wheels (46)
to one end of the Seat Carriage (12) with an M8 x
104mm Button Head Bolt (60) and an M8 Nylon
Locknut (65) as shown. Make sure the parts are
oriented as shown in the inset drawing; the
Seat Knob (not shown) will not engage the
Bench Rail (not shown) if they are incorrectly
oriented. Do not overtighten the Locknut; the
Bearing Wheels must be able to roll easily.
Attach two Bearing Wheels (not shown) to the
other end of the Seat Carriage (12) in the
same manner.
8. Attach the Seat Knob (45) to the Seat Carriage
(12) with two M6 x 13mm Bolts (59) and two M6
Nylon Locknuts (69). Make sure that the slot in
the Knob is aligned with the slot in the Seat
Carriage, as shown.
Orient the Seat (13), the Seat Backing (9), and
the Seat Carriage (12) as shown. Attach the Seat
and the Seat Backing to the Seat Carriage with
four 1/4” x 16mm Button Head Screws (82).
7
13
9
12
82
82
45
Slots
59
59
69
12
60
Attach second
set of wheels
here
65
42
42
39
46
46
Wide
Side
42
42
39
46
46
8
