16
37. Wrap the Butterfly Cable (81) around a “V”-Pulley
(38). Attach the Pulley and a Long Cable Trap
(50) to the indicated side of the bracket on the
Butterfly Upright (4) with a 3/8” x 2 1/2” Bolt (78)
and a 3/8” Nylon Locknut (74). Be sure the Long
Cable Trap is turned to hold the Cable in the
groove of the Pulley.
37
78
4
38
74
81
50
Bracket
38. Remove the two 3 1/2” Pulleys (37) and two
Cable Traps (44) from the set of Pulley Plates
(43). Wrap the Butterfly Cable (81) around the
Pulley. Reattach a Pulley and a Cable Trap to the
top set of holes in the Pulley Plates with a 3/8” x
2” Bolt (79) and a 3/8” Nylon Locknut (74). Be
sure the Cable Trap is turned to hold the
Cable in the groove of the Pulley.
38
44
37
74
79
81
39. Wrap the Butterfly Cable (81) around a “V”-Pulley
(38). Attach the Pulley and a Long Cable Trap
(50) to the other side of the bracket on the
Butterfly Upright (4) with a 3/8” x 2 1/2” Bolt (78)
and a 3/8” Nylon Locknut (74). Be sure the Long
Cable Trap is turned to hold the Cable in the
groove of the Pulley.
39
50
4
78
74
38
81
40. Secure a 3/8” x 1” Bolt (97) to the bracket on the
Right Butterfly Arm (18) with a 3/8” Nylon Jamnut
(88). Attach the end of the Butterfly Cable (81) to
the Bolt with another 3/8” Nylon Jamnut. Do not
tighten the second Nylon Jamnut; the Cable
must be able to pivot freely.
40
81
88
18
97
Bracket
43
