Toshiba TDP-XP1 Manual

A SERVICE OF

next previous

25

Operations

■ Turning the power off

1

Press the ON/STANDBY button.

A message appears on the screen, conﬁrming that you wish to shut off the power. To

shut off the power, press the ON/STANDBY button again. If you do not wish to shut off

the power, wait for a while without conducting any operations. The message will disap-

pear shortly. (This operation is no longer valid after the message disappears.)

2

Press the ON/STANDBY button again.

The screen turns off, but the internal cooling fan continues to operate for a short while.

Then, the projector goes into standby mode.

A B

FLASH

A

During cooling ,the ON/STANDBY indicator ﬂashes. In this state, the power can-

not be turned back on.

However, there is no problem with unplugging the power cord in this state.

B

In standby mode

Note

• Theprojectorconsumesabout6Wofpowerinstandby.Werecommendthatyouunplug

the power cord if you will not be using the projector for an extended period.

Precaution

• If the power cord is unplugged before cooling is complete, give the lamp time (about 5

minutes) to cool before plugging it back in. If the lamp overheats, it may fail to light.

• Rightafterturningoffthepower,theunitmaybecomeveryhot,especiallyairexhaust

and the bottom of the unit. Please handle with care to avoid burn injuries.

When cooling lamp After cooling complete