21
Preparations
Preparing and using the remote control
■ Loading dry-cell batteries
into the remote control
(1) Remove the battery cover.
(2) Insert the dry-cell batteries.
Be sure to align the plus and minus
ends of the batteries properly.
Two batteries (R03, size AAA) are
used.
(3) Put back the battery cover.
■ Point the remote control
toward the projector’s
infrared remote sensor and
press a button.
• Operating the projector from the front
• Operating the projector from the rear
Dry-cell batteries
• Before using the batteries, be sure to observe the Safety Precautions described in
previous pages.
• Remove batteries from remote control when not using for extended periods.
• If the remote control stops working, or if its range decreases, replace all the batteries
with new ones.
The remote control
• The remote control may fail to operate if the infrared remote sensor is exposed to
bright sunlight or fl uorescent lighting.
• Do not drop the remote control or strike it on a hard surface.
• Do not leave it in a hot or humid location.
• Do not get it wet or place it on top of wet objects.
• Do not take it apart.
• In rare cases, ambient conditions could impede the operation of the remote control. If
this happens, point the remote control at the main unit and repeat the operation.
