A SERVICE OF

logo

4 Replacement Procedures 4.6 MDC/Memory module
4.6 MDC/Memory module
Removing the MDC/Memory module
To remove the MDC/memory module, follow the steps below and refer to Figure 4-8 and 4-9.
1. Loosen the screw (with a washer) and remove the MDC/memory cover.
2. Remove the following screws securing the MDC.
M2×4B BIND screw ×2
3. Lift up the insulator and disconnect the MDC from the CN3010 on the system board.
4. Disconnect the MDC cable from the connector on the MDC.
MDC
CN3010
MDC cable
M2×4B BIND
Insulator
MDC/Memory cover
Screw (with a washer)
Figure 4-8 Removing the MDC
4-16 [CONFIDENTIAL] TECRA A8 /Satellite Pro A120 Maintenance Manual (960-573)