User’s Manual
69
2. Expanded Functions
Ethernet
IP address = 133.113.98.10
T3H T3H
(self-station) (target-station)
F5000 D4000
F5001 D4001
F5199 D4199
When R0030 is ON, 200 words data starting with D4000 of the T3H on which EN311 (IP address =
133.113.98.10) is installed, is read and stored in F5000 and after.
When the operation is completed, the status is set in RW060 and instruction output comes ON.
Note
•
Keep the input ON until the output comes ON.
•
This instruction becomes error complete in the following cases. (ERF = S0051 is set to ON)
(1) Target station No. is invalid. (for S20LP)
(2) Invalid register designation. (In case of T and C registers, T
→
T and C
→
C is only possible)
(3) Source/destination register address range is out of valid range.
(4) Destination register is write-protected.
(5) Response time-out is occurred.
(6) If expanded F register is designated;
- when MMR setting is not made.
- when IC card is not installed.
- when IC card is used to store program.
- when IC card is write-protected. (for destination)
•
By using SW067, self-station’s register write-protect is available.
F 9 8 7 6 5 4 3 2 1 0
SW067 SW C T F D RW LW W YW
0: Write enable
1: Write protect
•
Resetting the status register (operand
B
) is necessary at the first scan.
•
When using the TOSLINE-S20LP or Ethernet module (EN311), read the manual for these network
modules.
Both F register in CPU and
expanded F register in IC card
