A SERVICE OF

logo

Replacement Procedures
2.0*2.5
ODD bracket
Figure 4-13 Disassemble the side bracket
Installing optical disk drive
The following describes the procedure installing an optical disk drive.
1. Attach the ODD bracket to an optical disk drive and secure it with the following
screws.
M2.0× .5 Flat BIND screw x2
2. Insert an optical disk drive assembly into the slot and connect it to the connector on
the system board.
3. Secure the ODD drive with the following screw.
M2. X .0 Flat BIND screw x1
Satellite U400/Satellite Pro U400/PORTEGE M800 Maintenance Manual 4-26