Repair information 4-53
Interconnect card assembly removal
CAUTION: Unplug the printer before you begin.
Warning: When replacing any one of the following components:
• Operator panel assembly (or upper front cover)
• System board assembly
• Interconnect card assembly
Only replace one component at a time. Replace the required component and perform a POR before replacing a
second component listed above. If this procedure is not followed, the printer will be rendered inoperable. Never
replace two or more of the components listed above without a POR after installing each one or the printer will be
rendered inoperable.
Warning: Never install and remove components listed above as a method of troubleshooting components.
Once a component has been installed in a printer, it can not be used in another printer. It must be
returned to the manufacturer.
Warning: Observe all ESD precautions while handling ESD-sensitive parts. See “Handling ESD-sensitive
parts” on page 4-1.
Note: Any time the interconnect card assembly is replaced, the Configuration ID must be reset in NVRAM on
the new interconnect card. Go to “Configuration ID” on page 3-21.
1. Remove any feature or option cards from the interconnect card.
2. Remove the two screws securing the interconnect card.
3. Remove the interconnect card assembly.
