3. APPEARANCE
EO1-13016
3.3 Connectors
3- 2
3.3 Connectors
c
[Interface connector] (Serial interface model: D-SUB 25-pin Socket Connector,
Parallel interface model: IEEE 1284-B receptacle)
An interface cable which connects the printer to a POS terminal is connected to this connector.
A Centronics interface cable (Parallel I/F model) or an RS-232C interface cable (Serial I/F model)
is connected.
d
[Drawer interface connector] (6-pin modular connector)
A drawer cable which connects the printer to a drawer is connected to this connector. To this
connector, a TOSHIBA TEC drawer can be connected. Do not connect anything other than the
connectable drawer.
NOTE: For the connectable drawers, refer to your nearest authorised TOSHIBA TEC
representative.
e
[DC24V] (Socket connector)
The built-in AC adapter supplies +24V power to the printer through this connector. Do not connect
anything other than the built-in AC adapter.
f
[AC Inlet]
The AC power cord is connected to this inlet.
g
[Ground terminal]
The drawer interface cable’s ground wire is secured to this terminal.
CAUTION!
1. The drawer interface connector is exclusively for connecting the drawer. Do not connect
phone line or any other cables than the drawer cable to this connector. Doing so may cause
failure of the phone line and this printer.
2. To the DC24V connector (socket connector), do not connect anything other than the built-i
AC adapter.
3. The built-in AC adapter is exclusively for this printer. Do not use it for any other machines.
d
e
f
g
c
