4 © Titan Tool. All rights reserved.
English
Setup
Use the following procedures to set up your Transfer Pump.
Converting the Gun to Pressure Feed
Before using the HVLP Transfer Pump, it is necessary to convert
your spray gun from a cup gun to a pressure fed gun.
1. Loosen the retaining nut using a wrench and remove the
one quart cup assembly.
2. Pull the air tube off of the air tube tting on the spray gun.
Air tube
Retaining nut
Pressure cap
Cup assembly
3. Cap off the air tube tting with the air tube cap.
Optional: Follow steps 4 and 5 if you have a Maxum II
gun only.
4. Remove the air tube tting using a 1/4” wrench.
5. Thread the set screw into the air tube tting location and
tighten into place.
Set screw
Air tube fitting
Mounting the Transfer Pump
1. Make sure both the turbine and Transfer Pump are turned
OFF (0).
2. Locate the small connector cover on the top of the turbine.
Open the cover and slide the Transfer Pump into the
turbine cup holder.
NOTE: The cover should click over the locking tabs and
securely hold the pump in place.
3. Insert the inlet valve pusher tool into the inlet valve. This
will free the poppet valve from the valve seat, ensuring the
pump will prime properly.
NOTE: To prevent the poppet valve and seat from
sticking, make sure to follow all Cleanup
instructions after using the pump.
4. Dip the ends of the siphon and return tubes into solvent.
This will make them easier to secure to the Transfer
Pump.
5. Insert the suction and return tubes:
a. Press inward on the blue collar and rmly insert the
siphon tube (the larger tube) into the inlet valve tting.
b. Press inward on the blue collar and rmly insert the
return tube (the smaller tube) into the return tube tting.
c. Strongly pull on the tubes to make sure the connections
are secure.
Return tube
Collars
Siphon tube
