A SERVICE OF

logo

Removal and Replacement
Maintenance
6Ć22
c. Lift the hybrid away from the main board to complete its removal.
13. If you need to remove a BNC perform the following subparts:
a. Unsolder the wire to the center conductor of the BNC.
b. From the back of the board, remove the BNC nut and washer using
the BNC wrench (Item 14).
c. Pull the BNC from the front of the main board.
A01 Main Board
Wrench
Alignment Tool
Attenuator Shield
BNC
Attenuator Hybri
d
Attenuator Frame
TwistĆLock Tab
Figure 6Ć11:ăBNC and Hybrid Removal