Getting Started
7
Setting up the remote commander
Notes
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove the batteries
to avoid possible damage from battery leakage.
• Do not use a new battery with an old one together.
• Do not use different types of batteries together.
• Some buttons may not work with certain Sony TVs.
Controlling other TVs with the remote commander
The remote commander is preprogrammed to control non-Sony TVs. If your TV is
listed in the table below, set the appropriate manufacturer’s code number.
*
These buttons may not work with all TVs.
Tip
• When you set your TV’s code number correctly while the TV is turned on, the TV turns off
automatically.
Call up the on-screen display
DISPLAY
Change the Teletext page
c
/
C
Switch to/from wide mode of a Sony wide TV (For other
manufactures’ wide TVs, see “Controlling other TVs with
the remote commander”.)
WIDE
To Press
1
Set TV/VIDEO at the top of the remote commander to TV.
2
Hold down
?
/
1
, and enter your TV’s code number(s) using the programme
number buttons.Then release
?
/
1
.
Now you can use the following TV control buttons to control your TV:
?
/
1
, TV/VIDEO, programme number buttons, –/– – (ten’s digit), PROG +/–,
2
+/–,
a
(TV),
/
(Teletext), FASTEXT buttons, WIDE
*
, MENU
*
,
M
*
/
m
*
/
<
*
/
,
*
, and OK
*
.
continued
