Chapter 9 Maintenance and Troubleshooting
121
9-3 Alarms
a) With respect to setting of basic menu item 016
During recording and editing operations
Disc Damage off A command was received to record,
display an E-E picture, record an
essence mark, or add a quick scene
selection sub clip when there was no
free sparing area.
This disc cannot be recorded. Exchange
the disc.
Non AV Full off A command was received to record,
display an E-E picture, record an
essence mark, or add a quick scene
selection sub clip when there was no
free Non-Real-Time space.
Insert a different disc with enough free
capacity.
No Clip! limit A playback or search command was
received for a disc containing no
recorded clips.
These operations are not possible.
Disc Top! limit A PREV or reverse high-speed search
command was received with the disc
stopped at the top.
Disc End! limit A NEXT or forward high-speed search
command was received with the disc
stopped at the end.
TC EXT! on A time code or user bits preset
command was received with extended
menu item 626 “TC MODE” set to “ext
preset.”
Try the operation again after setting
extended menu item 626 “TC MODE” to
“int preset.”
See 8-3-2 “Extended Menu Operations”
(page 102) about how to make this setting.
REGEN mode! on A time code or user bits preset
command was received with extended
menu item 626 “TC MODE” set to “int
regen,” “ext regen,” or “rp188 regen.”
REC RUN! on A time code or user bits preset
command was received with extended
menu item 627 “RUN MODE” set to “rec
run.”
Try the operation again after setting
extended menu item 627 “RUN MODE” to
“free run.”
See 8-3-2 “Extended Menu Operations”
(page 102) about how to make this setting.
REC-PAUSE! on A time code or user bits preset
command was received with recording
paused.
Try the operation again after stopping
recording.
REC mode! limit A command to switch video or audio
signals was received during recording.
REC mode! limit A command to switch audio channels
was received during recording.
Message in time
data display
Display
condition
a)
Description Action
Message in time
data display
Display
condition
a)
Description Action
Disc Error! off Normal recording is not possible
because of a disc defect.
Use another disc.
You can check the state of a disc by
checking playback condition marks (see
page 44).
525/60 sig! limit An NTSC signal was input with this unit
in 625 line mode (PAL system).
Input a PAL signal.
625/50 sig! limit A PAL signal was input with this unit in
525(U) or 525(J) line mode (NTSC
system).
Input an NTSC signal.
