127-3 & 128-3
Table of Contents Previous Page | Next Page
21
FIG. 26. THE RUFFLER AND ITS PARTS
Ruffler
Lines 1, 2, 3, 4 and .5 shown in Fig. 26 indi-
cate where the material is to be placed for
various operations, as follows:
Line 1 -- the correct position for the material
to which the ruffled material is
applied.
Line 2 -- material to be ruffled.
Line 3 -- the facing for the ruffle.
Line 4 -- the strip of piping material.
Line 5--the edge to be piped.
Refer to Fig. 26 when inserting the material in
the ruffler.
The names and uses of the
principal parts of the ruffler are as fol-
lows:
(SEE: REFERENCES IN Fig. 26)
A -- FOOT -- the part by which the ruffler is
attached to the presser bar.
B -- FORK ARM-- the section that must be
placed astride the needle clamp.
C -- ADJUSTING SCREW -- the screw that
regulates the fullness of the gather.
D -- PROJECTION -- the part that projects
through tile the slots in the adjusting
lever
E-- ADJUSTING LEVER -- the lever that sets
the ruffler for gathering or for making a
plait once at every six stitches or once
at every twelve stitches, as desired: also
for disengaging the ruffler, when either
plaiting or gathering is not desired.
F -- ADJUSTING FINGER -- the part which
regulates the width or size of the plaits.
continued on next page...
