Using the RS 220
RS 220 | 17
Switching the loop through mode on/off
In loop through mode, the signals are looped through from one device to
another, even when the transmitter is switched off.
To switch the loop through mode on:
̈ Touch the touch key for selecting the audio source E on the trans-
mitter until the ANALOG LED B, the COAXIAL LED C and the
OPTICAL LED D light up green simultaneously for a moment.
̈ Switch the transmitter off. The ON LED G lights up red, the transmitter
is in loop through mode.
To switch the loop through mode off:
̈ Touch the touch key for selecting the audio source E on the trans-
mitter again until the ANALOG LED B, the COAXIAL LED C and the
OPTICAL LED D light up green simultaneously.
̈ Switch the transmitter off. The ON LED G is off, the transmitter is in
standby mode.
