[Table of Contents] [Previous Page] [Next Page]
10. ACCELERATOR & BRAKE
In the test mode, if the ACCEL. & BRAKE V.R. value is not within the allowable range, an adjustment
of V.R. installation position, or a replacement of V.R. is needed. Also, grease the MECHA's shafts and
sliding portions once every 3 months.
When performing the above work, take off the 4 truss screws and remove the front cabi's front lid.
10-1 ADJUSTMENT AND REPLACEMENT OF VOLUME
FIG. 10.1
The ACCEL. & BRAKE MECHA can be seen by removing the front lid. The ACCEL. V.R. is on the
left- hand side and the BRAKE V.R. is on the right-hand side of the MECHA. Check the V.R. value in
the test mode. The appropriate value of each V.R. is as follows:
Method of V. R. replacement
To replace the V.R., after taking off the connector from the V.R. to be replaced, take out the 2 screws
which secure the VR BRACKET, and remove the V.R. together with the bracket and gear. After the
re
lacement, check the V.R. value variations in the test mode.
When released: When ste
ed on:
ACCEL.: Under 2 DH <---> Over D3H
BRAKE: Under 2 DH <---> Over D3H
Pa
e 1 of 2Volume
7/12/2005htt
://www.sauservice.com/manuals/Da
tona%20Folder/DDhtml/DD35.html
