10. Verify that each radio has been pre-configured to communicate with the other by
checking the entries in the Call Book for each radio.
Enter “2” to Edit Call Book from the Main Menu.
For Master radio: The Number for Entry (0) should match the serial number
found on the bottom of the Slave radio.
For Slave radio: The Number for Entry (0) should match the serial number
found on the bottom of the Master radio.
To change the Number of an entry, enter the entry number followed by the seven-
digit serial number. Do not enter a “-“ after the third digit, the formatting of the
number is automatic. For example, to enter the serial number 901-4984 into Entry
(0), enter a “0” followed by “9014984” from the MODEM CALL BOOK menu.
Verify that the Call Entry selection of each radio has been pre-configured to
communicate with the other radio. This can be verified by checking the second
line of text in the MODEM CALL BOOK menu as shown above. The second line
of text should show the following:
Entry to Call is 00
If the second line of text does not show the same text as above, then select “C”
followed by a “0” to change the selection to the (0) Call Entry.
Press ESC to return to the Main Menu.
