Switching on FM radio
1 Press ON
•
OFF to power on the set.
➜ The LCD lights up.
2 Press DAB
•
FM to select FM mode if "FM" is
not displayed.
➜ Waveband and radio frequency are dis-
played
(see
5
).
Tuning to radio stations
1 In FM mode, press SCAN until frequency
number starts running.
➜ The radio will auto tune to a station of
strong signal strength, and search will
stop.
2 To tune to a weak station, press 1 / 2 until
an optimum reception is found.
3 Repeat the steps above until you find the
desired station.
Helpful hints:
– Befor pressing SCAN,you may first press
2
to select a scan up, or press 1 to select a
scan down.
Storing FM presets
You can store up to 10 FM stations on the 10
preset buttons each for easy access.
1 In FM mode, tune to your desired radio sta-
tion (Refer to "Tuning to radio stations").
2 Press and hold one of the preset buttons
(1-5) on the top of the set to store the pre-
set.
➜ "Station Saved" is displayed briefly on
the second line of the display, and the
stored preset number is displayed
(see
6
).
• To save on presets 6-10,first press SHIFT,
then press and hold the desired preset but-
ton for 2 seconds.
Helpful hints:
– If you have already saved a FM station in that
preset location, it will be overwritten by a
new station.
– When you store FM stations, these do not
overwrite your FM presets.
Selecting a preset FM station
1 In FM mode, press a preset button on the
top of the set to select presets 1-5.
• To select one of presets 6-10,first press
SHIFT, then press the desired preset button.
FM Radio
Sleep
The DAB radio has a built-in sleep timer,
which enables the set to be automatically
switched off during radio playback after a set
period of time.
Setting and activating the sleep timer
1 Switch on DAB or FM radio.
2 Press and hold SELECT for 2 seconds to
enter the timer setting mode (See 8).
3 Press
1 / 2 repeatedly to select your desired
timer option.
➜ The selections are toggled as follows
(5 minutes as a step):
90=85=70=65=60...=10=5=
SLEEP OFF
4 Press SELECT to confirm the selection.
5 The set will be switched off at the selected
time.
To deactivate the sleep function
1 In the timer setting mode, press 1 / 2 repeat-
edly until "Sleep Off" is displayed.
2 Press SELECT to confirm the selection.
Safety & maintenance informa-
tion
• Place the set on a flat, hard and stable surface
so that the system does not tilt.
• Do not expose the set, batteries, CDs to
humidity, rain, sand or excessive heat caused
by heating equipment or direct sunlight.
• The apparatus shall not be exposed to drip-
ping or splashing.
• Adequate ventilation with a minimum gap of
15cm (6 inches) between the ventilation
holes and surrounding surfaces is necessary
to prevent heat build-up.
• Do not cover the ventilation openings with
items such as newspapers, table-cloths, cur-
tains, etc.
• No objects filled with liquids, such as vases,
shall be placed on the apparatus.
• No naked flame sources, such as lighted can-
dles, should be placed on the apparatus.
• The mechanical parts of the set contain self-
lubricating bearings and must not be oiled or
lubricated.
•To clean the set, use a dry cloth. Do not use
any cleaning agents containing alcohol, ammo-
nia, benzene or abrasives as these may harm
the housing.
SLEEP Safety & Maintenance
(See 9)
