Appendix C: Intelli-M® Hardware Technical Specifications
42
Intelli-M Hardware Installation And Reference Guide
Power
Direct from PoE (Power over Ethernet) Switch
Note: PoE has not been UL verified.
Optional: External (24 VDC, 1 A) Power Supply
Note: Power Supply must be UL 294 listed with a power limited output rating of 9.5 to 24 VDC.
Communication
Ethernet -- 10 BaseT with a maximum distance of 100 meters (328 feet)
Cable -- CAT 5, CAT 5E, CAT 6
Reader Ports
There are 2 reader ports on an S-EIDC-U.
Reader Power -- 12 VDC @ 250 mA per reader port
Note: Shared with Output 1 and Output 2. Refer to “Outputs” below.
Reader Types -- Standard Wiegand
Note: Recommended standard Wiegand readers are the HID ProxPoint Plu 6005 series, HID ProxPro 5355
series, or XceedID model XF2100.
Note: Smart Card readers are not yet supported in the S-EIDC-U.
Inputs
There are 4 programmable inputs on an S-EIDC-U with configurable circuit type (contact closure or TTL)
and optional EOLR (End Of Line Resistor) supervision. Plus there is an integrated infrared tamper.
Note: The tamper sensor can be programmed within the Alarm Services of the Supervisor Plus software, and
must be enabled to meet UL requirements. Refer to the “Intelli-M Software Installation and Reference” manual.
The Supervisor Plus software has not been UL verified.
Outputs
There are 3 programmable outputs and a built-in warning buzzer output on an S-EIDC-U.
Outputs 1 & 2 -- Open collector outputs with electronic overload protection (max 450 mA @ 12 VDC)
Note: The eIDC provides 750 mA of continuous power:
• The maximum total of all output power from the eIDC is 750 mA.
• The maximum output of either reader is 250 mA.
• The maximum output from the combined open collectors is whichever of the following is less: 450 mA or
750 mA less the sum of the readers.
Output 3 -- Form C, SPDT relay output with configurable initial state (max 5 Amp @ 30 VDC)
Output 4 -- Built-in warning buzzer or alarm tone generator (max 85 dB)
Certifications
CE, FCC, ROHS, UL 294
