Helpful Hints
61
“Cannot set programme”
‘ Have the maximum number of programmes
already been set?
“A set programme is skipped”
‘ Are there at least 4 seconds between the edit
start point and the end point?
Editing may not be performed properly for a
programme with a set duration of less than
4 seconds.
“Cannot adjust the edit timing”
‘ The timing cannot be adjusted if the playback unit
that is connected does not have a Time code or
tape (linear) counter display.
Editing Controller does not work correctly
The symptom description is indicated in quotation “ ”.
“Editing controller does not operate correctly.”
‘ Remote controller transmitter beam is not
reaching the VCR. Ensure that Editing controller
is being pointed at the VCR and that the
transmitter beam is not obstructed.
‘ Distance is too far. Use Editing controller within
7 m of the VCR. If operation is not possible in this
range, replace the batteries.
‘ Batteries are spent. Replace the batteries. Note
the precautions for replacement on [R12].
‘ Batteries are incorrectly fitted with (+/-)
reversed. Fit the batteries correctly as shown on
page 12.
‘ Wrong remote control mode has been selected.
Set to the correct remote control mode [R24].
