48
Special Features
Pause Feature
(For Analogue PBX Line/Long Distance Service Users)
We recommend you to insert “Pause” if a pause is required for dialling with a PBX or to access a long
distance service. See page 72 for selecting the pause timing.
Make sure that the power is ON (p. 15), and the unit is in the standby mode.
H
Pause
Go Back
Ex. Line access number (PBX)
with the Handset/Base Unit
Phone number
OR
with the Handset
1 Press then .
2 Press and press to select “Pause”.
3 Enter a phone number.
• Selecting “Pause” creates a pause. “P” is displayed.
This prevents misdialling when you redial or dial a stored number.
•Selecting “Pause” more than once increases the length of the pause between numbers.
9
9P1234567
Key Lock
You can lock the handset keypad. Only incoming calls are accepted while the key lock is ON .
Make sure that the power is ON (p. 15), and the unit is in the standby mode.
To set the key lock
Press and hold until a beep sounds.
• “[X]” is displayed and all keypads are locked.
To cancel the key lock
Press and hold for about 2 seconds.
• “[X]” will disappear and the key lock will be cancelled.
• The key lock will also be cancelled when the power is OFF (p. 15).
• When the key lock is ON, emergency calls can not be made until the key lock is cancelled.
Base 1 [X]
10 New Calls
06.09 16:04
KX-TCD735ALM(E)-2(32~49) 2002.06.21 8:09 PM Page 48
