27
Preparation
“
To check the day/time
Repeat steps 1 to 6 on page 26.
≥The current day/time is heard. When finished, press (FUNCTION/EXIT/CH).
For Caller ID service users (p. 36)
≥The Caller ID information will re-set the clock after the first ring if the
adjusted time is incorrect. However, the day will not be re-set by the Caller
ID information. Adjust the correct day by following the steps on page 26.
≥If the time has not previously been set, the Caller ID information will not
adjust the clock.
≥The Caller ID information will automatically adjust the clock for daylight
saving time.
If a power failure occurs, “ ” will flash or the incorrect day/time will
be shown on the base unit display. Reprogram the current day/time.
≥In step 7, you cannot enter numbers greater than 12. Do not use military time.
(To set 13:00 hours, enter “0100” and select “PM” by pressing ($).)
