It is not possible to calibrate the minimum number of revolutions so that it is equal or
higher than the maximum number. The same goes the other way round.
Use
Unfold the conveyor belt open by using the
outer lever of the distributor (picture 3, lever
upwards to open it; lever downwards to close
it).
Turn the conveyor belt on by using the central
lever (picture 4. Lever in the middle means that
the conveyor is still; lever downward means
that the conveyor belt is moving). Start the
apron conveyor by using the control shackle
(picture 5) located on the front part of the
hopper. This shackle allows you to control the
direction of the apron conveyor (operator-
introduction-inversion-stop-hopper).
It is possible to control the speed of the
conveyor belt and of the apron conveyor
through the appropriate regulators located under
the corresponding levers (picture 6).
Once the operator has put his gloves, glasses and headphones on, he can start
introducing leaves, twigs and branches, provided that the input material has a
maximum diameter of 18 cm.
It is understood that when we say 18 cm, we mean the largest diameter, which can be
shredded, considering a soft or medium hard wood variety. It goes without saying
that if you use harder wood varieties, the maximum diameter you can shred decreases
proportionally.
The material to be minced can also be introduced in the hopper using a bucket or a
mechanical fork.
To get the best performances from the machine, we suggest you to insert the material
at a pace, which can allow the tractor to work over its maximum torque.
If you need to grind up wet material or fibrous materials such as linden trees, pines or
palms, please decrease the inserting speed to avoid any lodgements of the machine.
Accidental cases and what to do accordingly
(Please use the exploded diagram and the basic list of components at the end of the
this booklet)
Foto4
