© National Instruments Corporation 3 SCC-LP Series Lowpass Filter Modules User Guide
What You Need to Get Started
To set up and use the SCC-LPXX, you need the following items:
❑ SC-2345/2350 with one of the following:
– SCC-PWR01
– SCC-PWR02 and the PS01 power supply
– SCC-PWR03—requires a 7 to 42 VDC power supply (not
included)
❑ One or more SCC-LPXX
❑ SCC-LP Series Lowpass Filter Modules User Guide
❑ SC-2345/2350 User Manual, available at ni.com
❑ SCC Quick Start Guide, available at ni.com
❑ Read Me First: Safety and Radio-Frequency Interference
❑ SC-2345 Quick Reference Label
❑ 68-pin E Series DAQ device, documentation, and 68-pin cable
❑ 1/8 in. flathead screwdriver
❑ Numbers 1 and 2 Phillips screwdrivers
❑ Wire insulation strippers
❑ NI-DAQ (current version) for Windows 2000/NT/XP/Me
Note Software scaling of measurements is not supported on the Macintosh operating
system. Refer to the Using the SCC-LPXX when Scaling Voltage Measurements section for
more information.
