A SERVICE OF

logo

Page 8 of 9 Installation Instruction Sheet
LXE Spire Indoor/Outdoor Antenna Installation E-INS-6000SPIRE-F
Mounting Spire to I-Beam
The Spire Antenna may be mounted to an I-beam. The drawing below shows the I-Beam
clamp and screw configuration for the antenna mounting plate.
The screws must be tightened to a torque value of 40 in/lb (4.52 N/m).
Radome attaches to these studs.
Screw Mounting Hole
Use a #8 screw
(4 required)
Hose Clamp Mounting Hole
for attaching to Mast
3.312"
3.312"
Figure 5 I-Beam Configuration