Wireless-B PCI Adapter
9
1. After installing the Adapter,
the Windows XP Wireless
Zero Configuration icon
will appear in your comput-
er’s system tray (see Figure
4-7). Double-click the icon.
2. The screen that appears will show any available wireless network. Select the
network you want.
If this network has
WEP encryption
enabled, go to step 3.
If this network does
not have WEP
encryption enabled,
then the screen in
Figure 4-8 will
appear. Check the
box next to Allow me
to connect to the
selected wireless
network, even
though it is not
secure. Then click
the Connect button
and go to step 4.
Windows XP Wireless Zero Configuration
Important for Windows XP users: Windows XP has a built-in con-
figuration tool. Use the Windows XP Wireless Zero Configuration (in
the system tray at the bottom of your screen) to configure the Adapter.
Figure 4-7
Figure 4-8
Note: Steps 2 and 3 are instructions and screenshots for Windows XP
with Service Pack 1 installed. If you have not installed Service Pack
1, select the network you want, and click the Connect button. If the
network has WEP encryption enabled, enter the WEP key in the
Network key field, and then click the Connect button.
Instant Wireless
®
Series
8
3. The screen in Figure 4-5 may appear while the files are being copied.
4. After Windows has finished installing the driver, click the Finish button
from the screen shown in Figure 4-6.
The driver installation is complete. To configure the Adapter, proceed to
the next section, “Windows XP Wireless Zero Configuration.”
Figure 4-5
Figure 4-6
