A SERVICE OF

logo

Step 6: Installing an optional operator panel cover
15
Step 6: Installing an optional operator panel cover
Step 6: Installing an optional operator panel cover
An optional operator panel cover is provided with the MFP. To install the optional cover:
1 Locate the cover bracket packaged with your MFP.
2 Remove the backing from the tape on the rear of the cover bracket.
3 Align the holes in the cover bracket with the buttons on the operator panel, and then press it into place.
4 Align the cover with the cover bracket.
5 Press and hold the four corners against the bracket, and then slide the cover down until it snaps into place.