39
SETTING SYSTEM PARAMETERS
If you wish to connect your receiver to a DHCP server, use the
buttons to select the “On” setting.
If you wish to connect your receiver to a PC or laptop, the DHCP setting must be “Off”.
Note: Refer to our network function connection examples at the end of this
manual and the instructions on this subject available on the Internet under
“www.kathrein.de” “Service” → “Software and Downloading” → “Receiver” → “UFS 822”.
DHCP “On”
(DHCP server/router)
DHCP “Off”
(Hub/Switch/Direct
connection to PC or laptop)
Use the
buttons to select the “Get IP
Address” fi eld and confi rm by pressing the
button. Your DHCP server now indicates
the IP address to the receiver. As soon as the
receiver has been assigned its IP address by the
DHCP server (IP address is displayed), press
the
buttons to switch to the “Save” fi eld
and press the
button to confi rm.
Perform the settings for your network as required.
Use the
buttons to select the lines to be
changed; make the changes using the numeric
keypad. When you have completed all the
settings, press the
buttons to switch back
to the “Save” fi eld and press the
button to
confi rm.
Confi guration example:
Receiver:
IP Address: 192.168.0.11
Subnet Mask: 255.255.255.0
PC/laptop:
IP Address: 192.168.0.10
Subnet Mask: 255.255.255.0
If with the “DHCP On” setting no
connection can be established
between the receiver and DHCP
server/router, switch the setting
to “DHCP Off” and perform
the setting as described for
(DHCP “Off”).
