18
English
Basic Operating Procedure for Zone 2
On the front panel:
1. Press STANDBY/ON.
The STANDBY lamp goes off, and the ZONE 1 indicator lights
up on the display.
The buttons and controls on the unit work for Zone 1 operations.
2. Press ZONE 2 ON/OFF to activate ZONE 2.
The ZONE 2 indicator lights up.
• For more details, see “Turning the Power On and Off (Standby)
and Selecting the Zone 2 Operations” on page 26.
3. Press ZONE 2 CONTROL so that “ZONE2” and
the previously selected Zone 2 source name
appear on the display.
Now the buttons and controls on the unit work for Zone 2
operations.
4. Press one of the source selection buttons (except
DVD MULTI) to select a source and start
playback.
The sound comes out of the Zone 2 front speakers.
• For more details, see “Selecting the Zone 2 Source to Play” on
page 28.
• If no sound comes out of the Zone 2 front speakers, see
“Activating the Zone 2 Front Speakers” on page 29.
Note:
When “TV” has been assigned as the source to the
TV SOUND/DBS button, it does not work. To change the source
name, see “Changing the Source Name” on page 24.
5. Turn MASTER VOLUME to adjust the volume
level of the sound through the Zone 2 front
speakers.
• For more details, see “Adjusting the Zone 2 Volume” on page
28.
On the remote control:
When operating the receiver using the remote control, the unit’s
display always shows the Zone 1 source information though you
are operating it for the Zone 2 source.
1. Set ZONE 1/ZONE 2 selector to ZONE 2.
Now the buttons on the remote control work for Zone 2
operations.
2. Press AUDIO POWER ON.
The STANDBY lamp on the front panel goes off, and the
ZONE 2 indicator lights up on the unit’s display.
3. Press one of the source selection buttons (except
DVD MULTI) to select and play a source.
The sound comes out of the Zone 2 front speakers.
• For more details, see “Selecting the Zone 2 Source to Play” on
page 28.
• If no sound comes out of the Zone 2 front speakers, see
“Activating the Zone 2 Front Speakers” on page 29.
Note:
When “TV” has been assigned as the source to the TV/DBS
button, it does not work. To change the source name, see
“Changing the Source Name” on page 24.
4. Press VOLUME +/– to adjust the volume level of
the sound through the Zone 2 front speakers.
• For more details, see “Adjusting the Zone 2 Volume” on page
28.
The sources and functions available for Zone 2 operations
are limited.
For more details on Zone 2 operations, see “Zone 2 (Sub-room)
Operations” on pages 26 to 29.
LINEAR PCM
VOLUME
SPEAKERS 1 ZONE 2
ZONE 1
ZONE 2
The Zone 2 volume
level appears.
“ZONE2” appears.
The last Zone 2 source appears.
16-29_8040[C].p65 04.5.14, 11:2918
