39
English
IMPORTANT:
To operate JVC video components using this remote control:
• Aim the remote control directly at the remote sensor on the VCR or TV, not on
the receiver.
77
77
7 After pressing VCR, you can perform the
following operations on the VCR:
3 Starts playback.
4 Rewinds a video tape.
¢ Fast winds a video tape.
7 Stops operation.
8 Pauses. To resume playing, press 3.
You can always do the following on the VCR:
• Change the channels on the VCR using the VCR
CH +/– button.
• Turn on and off the VCR by pressing VCR in
the (Standby/On) section.
77
77
7 You can always perform the following operations
on the TV:
• Change the TV’s input mode to either “TV” or
“VIDEO” using the TV/VIDEO button.
• Change the TV volume using the TV VOL. +/–
button.
• Change the channels on the TV using the TV CH
+/– button.
• Turn on and off the TV by pressing TV in the
(Standby/On) section.
Note:
If you choose a source on the front
panel, the remote control will not
operate that source.
Operating Other Components
Notes:
• If you press SOUND
CONTROL, you cannot operate
the VCR with this remote
control. If this happens, press
VCR again, so operating
buttons for video components
will work for the VCR.
• If you press the VCR (the one
for the source selection) on the
remote control aiming at a JVC
TV, the TV’s input mode will
change to the video input.
CD
456
123
TV VCR AUDIO
EFFECT DELAY
3D-PHONIC
SURROUND
TEST
TAPE
7/P 8 9
10
SEA
PRESET
+10
TUNER/
BAND
VCR
SOUND
CONTROL
CD-DISC
VIDEO
RM-SR554RU REMOTE CONTROL
–+
PHONO
TV/
VIDEO
MUTING
ONE TOUCH
OPERATION
VCR CH
–+
CENTER
–+
REAR
–+
TV CH
–+
TV VOL.
–+
VOLUME
DAP MODE
SEA MODE
PTY SEARCH DISPLAY
–+
PTY SELECT
RX-554RBK(EE)_0118-001A_En24-42 98.1.30, 2:26 PM39
