EN 75
Master Page: Right
GR-DVM96-76U_37-79.fm Page 75
Select Scenes
6 Point the remote control at the camcorder’s
remote sensor. Press PLAY (U) and then press
R.A.EDIT ON/OFF on the remote control.
The Random Assemble Editing Menu appears.
7 If using a Wipe/Fader at the beginning of the
scene, press FADE/WIPE on the remote control.
● Cycle through the effects by pressing
repeatedly, and stop when the one you want is
displayed.
8 At the beginning of the scene, press EDIT IN/
OUT on the remote control. The Edit-In position
appears in the Random Assemble Editing Menu.
9 At the end of the scene, press EDIT IN/OUT. The
Edit-Out position appears in the Random
Assemble Editing Menu.
10 If using a Wipe/Fader at the end of the scene,
press FADE/WIPE.
● Cycle through the effects by pressing
repeatedly, and stop when the one you want is
displayed.
● If you select a Wipe/Fader effect for an Edit-Out
point, the effect is automatically applied to the
following Edit-In point.
● When you use Wipe/Fader effects, that time is
included in the total time.
11 If using Playback Special Effects, press EFFECT.
(੬ pg. 69)
12 Repeat steps 8 through 11 to register
additional scenes.
● To change previously registered points, press
CANCEL on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.
● If you are not using Wipe/Fader or Program AE
with special effects, repeat steps 8 and 9 only.
NOTES:
● When choosing a scene, set Edit-In and Edit-Out
points so that there is a relatively large difference
between them.
● If the search time for an in-point exceeds
5 minutes, the recording deck’s Record-Standby
mode will be cancelled and editing will not take
place.
● If there are blank portions before or after the Edit-
In and Edit-Out points, a blue screen may be
included in the edited version.
● Since time codes register time only as accurately
as seconds, the time code total time may not
match the total program time exactly.
● Turning off the camcorder’s power erases all
registered Edit-In and Edit-Out points.
● If you select Sepia or Monotone mode from
Program AE with special effects, you cannot use
the Black & White Fader. In this case the Black &
White indicator begins blinking. Once the next
Edit-In point is registered, the effect is turned off.
To combine these effects, use Sepia or Monotone
during recording, then use the Black & White
Fader during Random Assemble Editing.
● It is not possible to use Wipe/Fader effects and
Program AE with special effects during Random
Assemble Editing using a DV cable.
PLAY
CANCEL
R.A.EDIT
ON/OFF
FADE/WIPE
EFFECT
EDIT IN/OUT
Remote sensor
Random Assemble
Editing Menu
Selected parameter
1
2
3
4
5
6
7
8
––:–– ~
~
~
~
~
~
~
~
–
–
:
––
0
:
000
––
TOTAL
CODETIME
NIOUT
MODE
CONTINUED ON NEXT PAGE
GR-DVM96-76U_37-79.fm Page 75 Friday, February 15, 2002 11:55 AM
